2. Core Assembly
Overview
With the Top installed, we next build the rest of the Core using the Front, Bottom, and Rear modules.
Note: Bottom-mounted ABL
- Klicky: install the magnets and wiring to the Bottom beforehand.
- Beacon: wiring should be done beforehand. If soldering your Beacon wires to the PCB, you will also need to install the Beacon.
Parts
| Part | Qty |
|---|---|
| Rear Inlet | 1 |
| Bottom Horns | 1 |
| Front | 1 |
| M3 x 45mm SHCS | 4 |
| M3 x 6mm SHCS | 1 |
| Lock washer, M3 | 5 |
Steps
- Use a single M3 x 6mm screw and lock washer to fasten the Bottom Horns and Rear Inlet together.
- Put an M3 x 45mm screw and lock washer through each of the top two (2) screw holes on the Rear Inlet.
- Slide the screws from front to back through the holes on the Top.
- Take large, flat side of the Front and align the upper two (2) inserts with installed 45mm screws. Thread the screws in and tighten.
- Slide the remaining two (2) M3 x 45mm screws with lock washers through the bottom holes in the Rear Inlet. Thread the screws into the back of the Front component and tighten.