1. First Steps
Overview
First, we assemble the Top, including X axis endstop and cable guide/wire anchor.
Parts
| Part | Qty |
|---|---|
| Printed Top | 1 |
| Cable Anchor | 1 |
| Cable Guide | 1 |
| MGN12H carriage (X axis) | 1 |
| Horizontal limit switch | 1 |
| M3 x 8mm SHCS | 4 |
| M3 x 6m SHCS | 5 |
| Lock washer, M3 | 5 |
Steps
Note
If you printed a right-handed Top, reverse left and right in the directions below.
- The cable anchor attaches to the rear left of the Top with a lock washer and an M3 x 6mm screw. Orient the two inserts on the anchor to the rear or left side of the Top.
- Secure the cable guide to the cable anchor with two (2) M3 x 6mm screws.
- Align the endstop with the connector oriented upwards. Secure with two (2) M3 x 6mm screws.
- Set the assembled Top on the X axis MGN12H carriage. The wire cutout and cable anchor should be towards the rear of the printer.
- Attach the Top with four (4) lock washers and M3 x 8mm screws.