This is the last section of the build. Here we close up the bottom and top of the case.

Bottom Panel

Overview

Materials

Note that builds requiring a base extension will need longer screws.

As IllustratedStock and HSIFull HSIWith Base Extension (All Builds)

Parts	Qty	Note
M3 x 8mm machine screws	8
Closed Bottom Panel	1	Printed, two (2) files

Parts	Qty	Note
M3 x 8mm machine screws	8	May substitute 10mm or 12mm.
Bottom Panel	1	Printed, two (2) files

Parts	Qty	Note
M3 x 6mm machine screws	8
Bottom Panel	1	Printed, two (2) files

Parts	Qty	Note
M3 x 16mm machine screws	8
Bottom Panel	1	Printed, two (2) files
Base Extension	1	Printed, two (2) files

Directions

1. Line up the front bottom panel with the front base.

2. Use four (4) M3 x 8mm screws to attach the panel.

3. Use the same procedure for the rear bottom panel with four (4) more M3 x 8mm screws.

Reference

Lid(s)

The example below uses a single, long lid. The procedure for installing two short lids is the same and requires no additional fasteners.

Overview

Materials

As IllustratedStockHSI

Parts	Qty	Note
M3 x 6mm machine screws	8	May substitute longer screws.
M3 x 8mm machine screws	2
Long Carry Handle Lid	1	Printed
Carry Handle for Lids	1	Printed

Parts	Qty	Note
M3 x 8mm machine screws	8	May substitute 10mm or 12mm.
Lid	1-2	Printed

Parts	Qty	Note
M3 x 6mm machine screws	8	May substitute longer screws.
Lid	1-2	Printed

Note

The stock carry handle is illustrated, but there is also a version of the handle for heat set inserts.

Directions

1. Place the handle over the screw holes in the center of the lid.

2. Flip the lid over and fasten the handle in place with two (2) M3 x 8mm screws.

3. Place the assembled lid on top of the case. The lid is reversible.

4. Use eight (8) M3 x 6mm screws to attach the lid.

Reference

That's it!

You completed an OmniBox! Congratulations!