Core Assembly

Next we'll add the front and rear halves of the Main Body to the Base.

Attach the Main Body

Overview

Materials

As IllustratedStock and HSIFull HSI

Parts	Qty	Note
#6 x 3/4" sharp point screws	8
Main Body - Front - HSI.stl	1	Printed
Main Body - Rear - HSI - No Fans.stl	1	Printed

Parts	Qty	Note
#6 x 3/4" sharp point screws	8
Main Body - Front	1	Printed
Main Body - Rear	1	Printed

Parts	Qty	Note
M3 x 6mm machine screws	8
Main Body - Front - Full HSI.stl	1	Printed
Main Body - Rear - Full HSI.stl	1	Printed

Directions

1. Set the front and rear Main Bodies over the base and the align the edges.

2. Begin inserting #6 screws to the base, tightening about halfway. Before fastening each screw, check that the main body and base are still lined up.

3. Continue fastening screws halfway until all eight (8) are partially inserted.

Note: Alignment

If inserting the screws becomes difficult, back out and check:

• That both halves of the main body are still correctly aligned; and
• That the inserted screws are straight and not canted to the side.

4. Check for any alignment problems between the Base and Main Body. When satisfied, finish tightening the screws down completely.

Reference

Join the Main Body

Overview

Materials

Stock and HSIFull HSI

Parts	Qty	Note
M3 x 8mm machine screws	6	Can use 10mm screws instead.

Parts	Qty	Note
M3 x 6mm machine screws	6

Directions

1. Insert an M3 x 8mm screw in the top hole on one side of the rear Main Body. Fasten it to the mating hole on the front Main Body.

2. Repeat with the top hole on the other side of the Main Body, again fastening from back to front.

3. Use two (2) more M3 screws to fill in the remaining screw holes on one side.

4. Repeat with the final two (2) screw holes on the opposite side.

Reference

Attach the Crossbar

Overview

Materials

Parts	Qty	Note
M3 x 20mm machine screws	2
Main Body - Crossbar	1	Printed

Directions

1. Hold the crossbar between the screw holes at the top of the front main body. Note that the lip should face forward.

2. Fasten the crossbar in place with two (2) M3 x 20mm screws. Tightness can be adjusted to help square the sides of the case body.

Reference