Microcontroller Boards (MCUs)
This page lists microcontroller boards that are currently compatible with OmniBox.
MCU boards are mounted on MCU Trays. These parts are in the /Trays/MCU git folder, with each component in its own subfolder. There are STEP and Fusion 360 template files available for adding support for other boards.
For each entry, Materials are the fasteners required to mount the board, while the MicroSD Extension for the front panel is optional (but recommended).
Tip
Looking for a board that isn't listed? Open an issue!
Dual MCU Trays
Smaller MCUs can be mounted two-to-a-tray. See the Dual MCU git folder for available combinations.
BIGTREETECH
SKR Series
SKR 1.3 - 2.0
- Materials: 4x M3 x 6mm
- MicroSD Extension: Long
- Notes: SKR 3 and SKR 3 EZ are incompatible. See below.
SKR 3
Fit Test Pending: See Issue #48
- Materials: 4x M3 x 6mm
- MicroSD Extension: Long
- Notes: SKR 3 EZ and earlier SKR models are incompatible.
SKR 3 EZ
Fit Test Pending: See Issue #48
- Materials: 4x M3 x 6mm
- MicroSD Extension: Long
- Notes: Not compatible with other SKR trays.
SKR 3 E3 Series
All versions of the SKR E3 series are compatible with one tray, uncluding the Mini, Turbo, and RRF versions.
- Materials: 4-5x M3 x 6mm
- MicroSD Extension: Short
- Notes: Same mounting hole pattern as Creality 1.X/4.X boards.
SKR Pico
- Materials: 4x M3 x 6mm
- MicroSD Extension: N/A
- Notes: Same mounting hole pattern as Raspberry Pi.
Manta Series
The Manta M4P is not currently supported, but may be added in a future release.
Manta M5P
Fit Test Pending: See Issue #123
Manta M8P
Octopus Series
All members of the Octopus series are compatible with the mount below.
Creality
Creality 1.X & 4.X
- Materials: 4-5x M3 x 6mm
- MicroSD Extension: N/A, uses full-sized SD cards
- Notes: Compatible with version 1.x/4.x.
Creality 2.X
Contributed by Mr Meh
Printables - Creality 2.5.2 Board
- Materials: 4x M3 x 6mm
- MicroSD Extension: N/A, uses full-sized SD cards
- Notes: Tested with a 2.5.2 board
Duet3D
Duet 3 Mini 5+
Compatible with all versions.
- Materials: 4x M3 x 6mm
- MicroSD Extension: Short
Duet 3 6HC
Compatible with all versions.
- Materials: 4x M3 x 6mm
- MicroSD Extension: Short
FYSETC
FYSETC Spider 2.x
Contributed by MaffooClock
- Materials: 4x M3 x 6mm
- MicroSD Extension: Short
- Compatibility: 2.x tested; may work with 1.x
MakerBase
MKS Monster8
Fit Test Pending: See Issue #74
MKS Skipr
Contributed by Killajoedotcom
- Materials: 4x M3 x 6mm
- MicroSD Extension: Short
