Front Main Body

The front of the Main Body has eight (8) inserts, with four (4) canted at an angle for the display.

These instructions are the same for both HSI versions of the front Main Body.

Note

The display screen is at a 50 degree angle, not 45. The practice block has six holes at this angle for practice purposes.

It is important that the inserts are flush with the display surface.

Overview

Materials

Parts	Qty	Note
Heat set inserts, M3, 4.5x5.7mm	8
Main Body - Front - HSI - 40mm Internal.stl	1	Printed

Directions

1. Using four (4) inserts, place one in each of the two (2) lid holes and two (2) MCU tray holes.

2. Heat and set the inserts.

3. Turn the front body so that the four display panel mounting holes face you. Place inserts in each hole.

4. Carefully set the inserts, checking that the inserts finish flush with the surrounding plastic.

Reference