Printing Guide
This page has common settings for printing OmniBox and a printed component checklist. See the guided tour for help choosing the correct parts.
3D Printing Settings
Recommended Materials
- Modified PLA (PLA+/PLA Pro)
- PETG
- Unmodified PLA
OmniBox prints best with modified PLA. Printing in PETG typically takes longer than PLA but otherwise produces good results.
Unmodified PLA (generally prints at 180-200C) is prints easily but is a rigid, weak material. Modified PLA is more flexible, among other benefits.
Note
Fan gaskets are an optional noise reducer and require TPU.
Print Settings
These settings are consistent for all parts but the optional fan gaskets.
| Setting | Value | Notes |
|---|---|---|
| Layer Height | 0.2-0.24mm | Coarser settings have not been tested. |
| Adaptive Layer Height | Optional | Can improve appearance and reduce print time. |
| Perimeters (Walls) | 1.2mm+ | 3 perimeters with a 0.4mm nozzle. 1.5mm+ results in solid main body side walls. |
| Infill | 20-25% | Cubic is a good tradeoff for time and durability. |
| Nozzle Diameter | 0.4mm, 0.6mm | If you print a case with a different nozzle size, please share your results! |
| Support Overhang Angle | >= 60 degrees | This reduces print time & support material. |
PETG Settings
- Use 1.6mm walls/perimeters (1.8mm for 0.6mm nozzles).
- If printing in a drafty room, consider a partial enclosure to help layer adhesion.
Core Component Settings
- Supports must be on.
- Support blockers are recommended for zip tie anchors and fastener holes.
- Use a brim or adhesive for large parts.
- Cantilever bed printers (e.g., Ender 5 Pro) should move heavier prints to the supported side of the bed.
Printed Component Checklist
This is a checklist of types parts to print. See the Guided Tour for help selecting the right STL files from the git repository.
Core
| Component | Quantity | Required | Notes |
|---|---|---|---|
| Base - Front | 1 | Yes | |
| Base - Rear | 1 | Yes | |
| Main Body - Crossbar | 1 | Yes | |
| Main Body - Front | 1 | Yes | See the tour on choosing a version to print. |
| Main Body - Rear | 1 | Yes | See the tour on choosing a version to print. |
| Base Extension | 1 | See note | Required when using a Mean Well RSP-500 power supply, otherwise optional. |
Trays
| Component | Quantity | Required | Notes |
|---|---|---|---|
| PSU Tray | 1 | Yes | |
| MCU Tray | 1 | Yes | |
| CPU Tray | 0-1 | No | If unused, replace with an extra side panel. |
| Lower Bay Trays | 0-6 | No | Type and quantity are specific to configuration. |
Panels
| Component | Quantity | Required | Notes |
|---|---|---|---|
| Display Mount | 1 | Yes | |
| Lid | 1-2 | Yes | One (1) long lid or two (2) short lids. |
| Rear Panel | 1 | Yes | |
| Bottom Panel | 1 | Yes | |
| Side Panel | 1-2 | Yes | One (1) with a CPU tray, two (2) without. |
Other Components
| Component | Quantity | Required | Notes |
|---|---|---|---|
| Fan Cages | See note | Yes | Quantity and type depend on configuration. |
| Fan Gaskets | See note | No | Optional add-on to fan cages. |