Clock 3 Documentation
Connections Overview
Initializing search
GitHub
Clock 3 Documentation
GitHub
Overview
About
About
Features
Gallery
Development Goals
Frequently Asked Questions
Status
Status
Changelog
Roadmap
Release Log
Bill of Materials
Bill of Materials
Bill of Materials Introduction
Printed Parts
Decision Guide
Bill of Materials
BOM Source Repository
Assembly Guide
Assembly Guide
Assembly Guide Introduction
Preparation
Preparation
Getting Ready & Organized
Fabrication Checklist
Frame Labels
Heat Set Inserts
Linear Rail Installation
Roll-In Tee Nut Installation
Z Axis Linear Rail Alignment
Frame Assembly
Frame Assembly
Overview and Instructions
Side Frames
Joining the Halves
Z Framing
Prepare Insulation
XY Framing
Finishing Touches
X and Y Axes
X and Y Axes
XY Axes Overview
Stepper Pulley Assembly
Tensioners
XY Joint
Y Rail Alignment
A and B Steppers
X Gantry and Belts
Z Axis
Z Axis
Z Axis Overview
Bed Frame Assembly
Stepper Installation
Z Gantries
Heated Bed Installation
Finishing the Z Axis
Electronics, Part 1
Electronics, Part 1
Initial Electronics Overview
First Extrusion
Second Extrusion
Rear Skirt
Front Skirt
Toolhead Setup
Wiring Fabrication
Wiring Fabrication
Wiring Fabrication Overview
Electronics, Part 2
Electronics, Part 2
Connections Overview
Light Installation
Finishing Out the Toolhead
Finishing Out the Enclosure
Finishing Up
Finishing Up
Last Steps
Configuration
Configuration
Configuration Introduction
Connections Overview
This document is a placeholder until more content is generated.