Skip to content

Fabrication Checklist

This document is actively being refined and edited for mistaeks.

Before we start making a mess, let's make sure you have a few things and do get a few parts ready.

1. Frame

You should have all of the aluminum extrusion pieces listed in the Framing section of the BOM. We're going to label the extrusion pieces next, so we recommend keeping them sorted by length and width for now.

2. Panels

Before you begin assembly, it's a good idea to have the wood and acrylic panel fabrication completed. Sometimes it can take awhile to find a fabricator, get a quote, and have the work produced. We'll need the floor pieces to help align the Z axis crossbars, and all of the panel pieces are helpful in marking out the insulation cuts.

If you plan to paint/stain and/or seal your panels, bear in mind that any sealant will need to have cured before attaching the insulation with adhesive.

3. Door Panel Gaskets

The door panel gaskets (PNs 713 and 714) probably aren't cut to size yet. Keep them handy--we'll cut those shortly.

4. Insulation

TODO

5. Printed Parts

We'll be adding heat set inserts soon, so your printed parts need to be finished before then.

6. Wiring

Unless you're having your wiring made or are experienced at wire crimping, we recommend practicing making connectors and watching/reading about crimping wires.

Warning

Poor electrical connections and loose wiring can cause a fire. It's very important that you're able to consistently make good crimps.