Printed Parts
This document is actively being refined and edited for mistaeks.
Note
Which parts use primary and secondary colors have not been firmly set. This page will later contain information on this, as well.
1. Print Settings
ABS
| Setting | Value | Notes |
|---|---|---|
| Layer Height | 0.24mm | |
| Initial Layer Height | 0.2mm | |
| Layer Width | 0.4mm | |
| Surface Layers | 5 | |
| Perimeters/Walls | 5 (2mm) | |
| Infill | > 25% | Non-structural parts can be printed at 20% |
| Supports | No |
TPU
| Setting | Value | Notes |
|---|---|---|
| Layer Height | 0.2mm | |
| Initial Layer Height | 0.2mm | |
| Layer Width | 0.4mm | |
| Surface Layers | 5 | |
| Perimeters/Walls | 4 (1.6mm) | Print feet at 6/2.4mm |
| Infill | 25% | Print feet at 35% or higher |
| Supports | Yes |
2. Parts and Quantity
You can find the STL Files here. The number of each part to print is specified in the Bill of Materials, along with a direct link.
3. Heat Set Inserts
Many of the parts for Clock 3 require heated inserts. Once you see these in action with ABS, a whole world of possibilities opens. We have two suggestions:
- Get a heat set insert press or make one (ex. 1, ex. 2). It's an investment. Trust us.
- Practice ahead of time on the practice block. It will use a few inserts, but you'll feel more comfortable working on the printed parts.